HP 625n Gigabit Ethernet Print Server manual Configuration Parameters 2, Wpa-Psk

Table 4.3	802.11 Configuration Parameters (2 of 4)
Item		Description
Open System		(No authentication) Select this authentication method if your
		wireless network does not require device authentication or
		security to access the network. However, your network may still
		use WEP encryption keys for data privacy.
Shared Key		(Requires a WEP key) Select this authentication method if each
		device on your wireless network uses a shared encryption key
		(that is, a shared "password" value) for network access and
		communications. Each device on the network must use the same
		key. The HP Jetdirect print server supports IEEE 802.11 Wired
		Equivalent Privacy (WEP) keys for encrypted network
		communications. If you select Shared Key authentication, you
		must configure one or more WEP keys.
WPA-PSK		Select Wi-Fi Protected Access Pre-Shared Key (WPA-PSK) for
		advanced authentication. WPA-PSK is typically for small networks
		where authentication servers are not used. If WPA-PSK
		authentication is selected, you will need to enter a network
		pass-phrase that is used to generate the pre-shared key for your
		network. In addition, you will need to select dynamic encryption.
Pass-phrase		Enter a network pass-phrase that will be used to generate the
		pre-shared key for WPA-PSK authentication on your network.
		A pass-phrase must be from 8 to 63 ASCII characters in the
		hexadecimal range 21 through 7E (characters 0-9, a-z, A-Z and
		numerous special characters including !, @, #, $, %, ^, &, (, ), _,
		+, =, -, {, }, [, ], \, /, “, <, >, ?, “, ‘, ~).
Disabled (No		Select Disabled if your wireless network does not use encryption
encryption)		keys for network access or communications.
Dynamic		(WPA-PSK authentication only) When configured for WPA-PSK
		authentication, the print server must use dynamic WPA encryption
		protocols.

ENWW Using the Embedded Web Server 113