HP 625n Gigabit Ethernet Print Server manual Using the Embedded Web Server

Using Telnet to Erase the Existing IP Settings

To erase the IP address during a Telnet session, use the following command line entries:

1.Type cold-reset, then press Enter.

2.Type quit, then press Enter to exit Telnet.

3.Power the print server off/on.

Note	This procedure resets all TCP/IP parameters, but
	only affects the TCP/IP subsystem. Parameters for
	other subsystems such as IPX/SPX or AppleTalk are
	not affected.
	To reset all parameters to factory default values,
	refer to Chapter 8.

Using the Embedded Web Server

You can set IP parameters on HP Jetdirect print servers that support the embedded Web server. For more information, refer to Chapter 4.

ENWW TCP/IP Configuration 98