Table 4.8 | Miscellaneous Settings (3 of 5) | |
Item |
| Description |
|
| |
Scan Idle Timeout | Specifies the number of seconds that an idle connection for | |
|
| scanning is allowed to remain open. The maximum is 3600, and |
|
| the default is 300. If set to 0, the timeout is disabled and the |
|
| connection will remain open until closed by the network system |
|
| that is accessing the device. |
|
|
|
Locally |
| Specifies a locally administered address (LAA) that replaces the |
Administered |
| |
Address |
| a |
|
| entered. |
|
| For Ethernet print servers, the LAA address must start with |
|
| hexadecimal X2, X6, XA, or XE, where X is any hexadecimal digit |
|
| 0 through F. |
|
| The default address is the factory assigned address. |
|
| |
Syslog Facility | Specify the encoded source facility of a message (for example, | |
|
| to identify the source of selected messages during |
|
| troubleshooting). By default, the HP Jetdirect print server uses |
|
| LPR as the source facility code, but local user values of local0 |
|
| through local7 can be used to isolate individual or groups of print |
|
| servers. |
|
|
|
On fatal error |
| (Supported external print servers only) Specify the print server’s |
|
| action when it detects a fatal error during operation with the |
|
| attached device: |
|
| ● Halt (default): The print server’s networking operation is |
|
| suspended. User intervention will be required. |
|
| ● Reboot: The print server will restart, similar to when the printer |
|
| is powered off/on. |
|
| |
Error page type | (Supported external print servers only) Specify the type of | |
|
| diagnostic page that will automatically print on a fatal error. |
|
| ● Basic (default): A Default Diagnostic Page will print. It is a |
|
| single page containing an error summary in |
|
| form. |
|
| ● Full: Up to five pages of full diagnostic information will be |
|
| printed.; These pages will contain detailed status of the print |
|
| server at the time the error was detected. HP support |
|
| personnel may be required to interpret the pages. |
|
| ● None: A diagnostic page will not be printed. |
|
|
|
Dynamic Raw |
| Allows additional ports to be specified for printing to TCP port |
Port Setting |
| 9100. Valid ports are 3000 to 9000, which are |
|
| |
|
|
|
|
|
|
ENWW | Using the Embedded Web Server 125 |
