TCP/IP Protocol Information
Information in this section of the Jetdirect configuration page is described in Table 9.6. For error messages, see Table 9.11.
Table 9.6 | TCP/IP Configuration Information (1 of 4) | |
|
|
|
Message |
| Description |
|
|
|
STATUS: |
| Current TCP status. |
|
| READY: Indicates the HP Jetdirect print server is awaiting |
|
| data over TCP/IP. |
|
| DISABLED: Indicates that TCP/IP was manually disabled. |
|
| INITIALIZING: Indicates that the print server is searching |
|
| for the BOOTP server, or trying to get the configuration file |
|
| through TFTP. An additional status message may also be |
|
| displayed. |
|
| An error code and message is displayed if the print server |
|
| is not ready. For more information, see Table 9.11. |
|
| |
HOST NAME: | The host name configured on the print server. It may be | |
|
| truncated. |
|
| NOT SPECIFIED: Indicates that no host name was |
|
| specified in a BOOTP response or TFTP configuration file. |
|
| NPIxxxxxx: The default name is NPIxxxxxx, where xxxxxx |
|
| represents the last six digits of the LAN hardware (MAC) |
|
| address. |
|
| |
IP ADDRESS: | The Internet Protocol (IP) address assigned to the | |
|
| HP Jetdirect print server. This is a required entry for |
|
| operation of the print server on a TCP/IP network. During |
|
| initialization, a temporary value 0.0.0.0 is displayed. After |
|
| two minutes, a default IP address 169.254/16 or |
|
| 192.0.0.192 is assigned. |
|
| NOT SPECIFIED: Indicates that an IP address is not |
|
| assigned or the value is zero. |
|
| |
SUBNET MASK: | The IP subnet mask configured on the HP Jetdirect print | |
|
| server. During initialization, a temporary value 0.0.0.0 is |
|
| displayed. Depending on configuration parameters, the |
|
| print server may automatically assign a usable default |
|
| value. |
|
| NOT SPECIFIED: Indicates that a subnet mask is not |
|
| configured. |
|
|
|
ENWW | HP Jetdirect Configuration Page 215 |
