Table 3.4 Telnet Commands and Parameters (17 of 18)

status-page-lang

Specifies the printer job language (PJL) that the print server

 

will use to send the Jetdirect configuration/status page to the

 

printer.

 

Auto (default): The PDL is auto-detected when the print

 

server is powered on or after a cold-reset.

 

PCL: Hewlett-Packard Printer Control Language

 

ASCII: Standard ascii characters

 

HPGL2: Hewlett-Packard Graphics Language (v2)

 

PS: Postscript language

 

 

link-type

(10/100 Fast Ethernet) Sets the print server’s link speed (10

 

or 100 Mbps) and communication mode (Full- or

 

Half-Duplex). Selections are AUTO, 100FULL, 100HALF,

 

10FULL, 10HALF.

 

For AUTO (default), the print server uses autonegotiation to

 

determine the link speed and mode. If autonegotiation fails,

 

then 100HALF is set.

 

 

network-select

(For HP Jetdirect products with a dual wired/wireless port,

 

such as model ew2400) Specifies the active behavior of the

 

print server.

 

Auto (default): Automatically detects whether a network

 

cable is attached. If a network cable is not attached, only

 

the IEEE 802.11g wireless port will be active. However,

 

if a network cable is attached, then only the IEEE 802.3

 

wired port will be active. Use caution when plugging

 

in a network cable on an active wireless network.

 

Wireless access to the device will be terminated.

 

Wired: Only the 802.3 wired port will be active.

 

Wireless: Only the 802.11g wireless port will be active.

 

 

job-timeout

(External print servers only) Specifies the time period after

 

which an idle connection to the printer (for example, through

 

the USB port) will be closed.

 

An integer from 30 to 4294967295 seconds may be

 

specified. If 0 is specified, the default value of 270 seconds

 

is used.

 

 

Support

 

Command

Description

 

 

Web JetAdmin URL

(Read-only parameter) If HP Web Jetadmin discovers this

 

device, the URL to access HP Web Jetadmin will be

 

specified.

 

 

Web JetAdmin

(Read-only parameter) If HP Web Jetadmin discovers this

Name

device, the name of the HP Web Jetadmin host will be

 

specified (if known).

 

 

support-name

Typically used to identify the name of a person to contact for

 

support of this device.

 

 

ENWW

TCP/IP Configuration 95

Page 95
Image 95
HP 625n Gigabit Ethernet Print Server manual Telnet Commands and Parameters 17, Support Command Description