HP 625n Gigabit Ethernet Print Server manual Telnet Commands and Parameters 12

Table 3.4 Telnet Commands and Parameters (12 of 18)

phone-home-config	Specifies privacy settings on the print server during
	embedded Web server access. This command controls
	whether statistical data on product use may be sent to HP.
	For HP to collect data, Internet access is required.
	2: Prompt the user to allow sending data on initial access to
	the Networking tab of the embedded Web server. This is the
	factory-default and cold-reset value. Once changed, this
	value cannot be re-selected.
	1: Allows the sending of data to HP without prompting the
	user.
	0: Disables sending data to HP without prompting the user.
TCP/IP Diagnostics
Command	Description
Last Config IP	(Read-only parameter) The IP address of the system from
	which the HP Jetdirect print server’s IP address was
	configured.
TCP Conns Refused	(Read-only parameter) The number of client TCP
	connections that are refused by the print server.
TCP Access Denied	(Read-only parameter) The number of times that client
	systems were denied access to the print server because
	there was no allowable entry in the print server’s host access
	list.
DHCP Lease Time	(Read-only parameter) DHCP IP address lease duration
	time (seconds).
DHCP Renew Time	(Read-only parameter) DHCP T1 timeout, specifying the
	DHCP lease renewal time (seconds).
DHCP Rebind Time	(Read-only parameter) DHCP T2 timeout, specifying the
	DHCP lease rebind time (seconds).
SNMP
Command	Description
snmp-config	Enables or disables SNMP operation on the print server.
	0 disables, 1 (default) enables SNMP.
	CAUTION: Disabling SNMP will disable all SNMP agents
	(SNMP v1, v2, v3) as well as communications with
	management applications, such as HP Web Jetadmin. In
	addition, firmware upgrades through current HP
	downloading utilities will be disabled.
get-cmnty-name	Specifies a password that determines which SNMP
	GetRequests the HP Jetdirect print server will respond to.
	This is optional. If a user-specified get community name is
	set, the print server will respond to either a user-specified
	community name or the factory-default. The community
	name must be ASCII characters. The maximum length is
	255 characters.

ENWW TCP/IP Configuration 90