IPX/SPX Protocol Information
Information in this section of the Jetdirect configuration page is described in Table 9.7. For error messages, see Table 9.11.
Table 9.7 IPX/SPX Configuration Information (1 of 2)
Message | Description |
|
|
STATUS: | Indicates the current IPX/SPX protocol status. |
| READY: Indicates the HP Jetdirect print server is awaiting |
| data over IPX/SPX. |
| DISABLED: Indicates that IPX/SPX was manually disabled. |
| INITIALIZING: Indicates that the print server is registering |
| the node address or name. An additional status message |
| may also be displayed. |
| An error code and message is displayed if the print server |
| is not ready. For more information, see Table 9.11. |
|
|
PRIMARY FRAME | Specifies the frame type selection on the Jetdirect print |
TYPE: | server. |
| AUTO SELECT: The print server automatically senses and |
| limits the frame type to the first one detected. |
| EN_8023: Limits the frame type to IPX over IEEE 802.3 |
| frames. All others will be counted and discarded. |
| EN_II: Limits the frame type to IPX over Ethernet frames. |
| All others will be counted and discarded. |
| EN_8022: Limits the frame type to IPX over IEEE 802.2 with |
| IEEE 802.3 frames. All others will be counted and |
| discarded. |
| EN_SNAP: Limits the frame type to IPX over SNAP with |
| IEEE 802.3 frames. All others will be counted and |
| discarded. |
|
|
ENWW | HP Jetdirect Configuration Page 219 |
