HP 625n Gigabit Ethernet Print Server manual Telnet Commands and Parameters 16

Table 3.4 Telnet Commands and Parameters (16 of 18)

webscan-config	(Web Scan Config) Enables or disables the Web Scan
	feature on the print server when connected to a supported
	device. 0 disables, 1 (default) enables.
scan-idle-timeout	Specifies the number of seconds (1 - 3600) that an idle scan
	connection is allowed to remain open. 0 disables the
	timeout. The default is 300 seconds.
scan-email-config	(Email Scan Config) Enable or disable the scan-to-email
	feature in the Web Scan server. 0 disables, 1 (default)
	enables.
MFP-config	(MFP config) Enable or disable print server support of the
	client software provided with your multifunction or all-in-one
	peripheral.
	0 (default): disables client software support (allows printing
	only).
	1: enables client software support (allows printing and
	scanning).
usb-mode	Specifies the communication mode over the USB port on the
	HP Jetdirect print server.
	● Auto (default): Automatically negotiates and sets the
	highest communication mode possible for the attached
	printer or device.
	● MLC: (Multiple Logical Channels) An HP-proprietary
	communication mode that allows multiple channels of
	simultaneous print, scan and status communications.
	● BIDIR: A standard connection that supports
	bi-directional communications between the printer and
	print server. The print server sends print data and
	receives status from the printer.
	● UNIDIR: A standard connection in which data is
	transferred in one direction only (to the printer).
usb-speed	(Read-only parameter, USB 2.0 products only) Specifies the
	autonegotiated communication speed over the USB
	connection between the HP Jetdirect print server and the
	device.
	● Full Speed: 12 Mbits/sec as specified in the USB v2.0
	specifications, compatible with USB v1.1 specifications.
	● Hi-Speed: 480 Mbits/sec for USB v2.0 devices only.
	● Disconnected: The USB port is not connected.

ENWW TCP/IP Configuration 94