Bosch Appliances D1265 Passcode Protected Commands and Functions, Turning the System On Arming

D1265 Owner's Manual Part II: System Commands

Passcode Protected Commands and Functions

Commands and/or Functions within your system might be programmed to require a valid passcode prior to gaining access to that function. This ensures that only authorized people have access to specific functions.

1.The display might prompt you to enter your passcode.

2.The passcode is shown as asterisks (*) when entered and advance from the right side of the display to the left until all passcode digits (from a minimum of 3 to a maximum of six) are entered.

3. Press ENTER.

Turning the System On (Arming)

Your security system can be turned on (armed) in many different ways, depending on the arming command used. Arming Commands are those commands used to turn the system on. The most basic arming command is to arm the entire system.

There are several other arming commands to turn the system on. These are described later in this manual.

To Turn Your Security System On (Arm)

1.Enter your passcode and press ENTER.

2.After you arm your system, the keypad emits a repeating beep tone, shows Exit now! # seconds remaining and counts down the exit delay time.

Turning the System Off (Disarming)

Entering your personal passcode turns off your security system. When the system is turned on, you must enter through a designated entry door to prevent an instant alarm condition. Opening the door starts entry delay time and the keypad emits a pulsing “beep” tone to remind you to turn the system off. Enter your passcode before the delay time expires and the system turns off.

If you enter through the wrong door or fail to disarm before the entry delay time expires, you cause an alarm.

If this happens, silence the alarm (by entering your personal passcode and pressing ENTER) and call your security company to let them know that it is not an emergency situation.

If enabled by your security company, there is a short period of time after the start of the alarm that a passcode entry aborts the transmission of the alarm report. Alarm Aborted shows if this occurs.

To Turn Your Security System Off (Disarm):

1.Enter your passcode and press ENTER.

2.You must press the ENTER button within 5 sec of entering your passcode, or the passcode entry is invalid.

3.The display returns to idle disarmed text.

16 Bosch Security Systems, Inc. 9/10 F01U169130-02