Bosch Appliances D1265 owner manual Before you begin, keep these points in mind

If you prefer, you might use the function

list in place of Steps 2 and 3 to initiate this function.

Press the Menu button to enter the function list.

Press the Next button repeatedly.

When you reach the Add/Change User button, press it.

Bosch Security Systems, Inc. 9/10 F01U169130-02

3.

Press the 5 button and then the 6 button.

2.

Ensure your keypad shows idle disarmed text.

Press the CMD button. The display shows *System Command*.

1.

D1265 Owner's Manual Part III: Advanced Commands

Contact your security company if you don’t know what user numbers, authority levels, or areas are available. Refer to the Appendix on page 67 for further information on adding passcodes.

Before you begin, keep these points in mind:

Do not try to add new users without knowing the available user numbers. An already defined user number is overwritten when the new user is defined. These are two or three digit numbers, not to be confused with passcodes that identify users at your security company.

When choosing passcodes, choose a new passcode three to six digits long. If you choose a passcode with the same digit in consecutive order (for example “33” in 334697), take care when entering it.

To avoid conflicting with other passcodes and duress codes, your system will not let you change passcodes that are the same within plus or minus 2 of an existing passcode. For example, if 1234 were an existing code, your system would not let you add or change your code to 1232, 1233, 1234, 1235, or 1236.

Choose an authority level for each area. Not assigning the authority level for an area denies the passcode access to that area.

4.The display changes to show Add / Change User Enter user #:

5.Enter the user number and press the ENTER button.

6.The display changes to show the user number entered and the user’s name (if any).

(User 3 is used as an example.)

Press the Continue button to proceed on to changing the user’s information.

If there is no name for the user, the default user name text appears in the second line.

(User 3 is used as an example.)

Press the Continue button to change the user’s information.

7.The display changes to Add/Change Menu.

The display varies depending on the type of control panel that was installed in your system.

Door access control in the control panel (D9412GV2, D9412GV3, D7412GV2, D7412GV2)

My system does not have door access control in the control panel (D7212GV3, D7212GV2)

49