Bosch Appliances D1265 owner manual Display Rev CMD + 5 +, Service Menu 9 + 9 + Enter

1. Ensure your keypad shows idle disarmed text.

2. Press the 9 button twice.

3. Press the ENTER button.

4. The display changes to show the service menu.

Service Walk Test appears on D9412GV2 and D9412GV3 control panels only.

D1265 Owner's Manual Part III: Advanced Commands

Display Rev (CMD + 5 + 9)

1.Ensure your keypad shows idle disarmed text.

2.Press the CMD button. The display shows *System Command*.

3.Press the 5 button and then the 9 button.

If you prefer, you might use the function list in place of Steps 2 and 3 to initiate this function.

Press the Menu button to enter the function list.

Press the Next button repeatedly.

When you reach the Display Revision button, press it.

4.The display changes to *BOSCH D7412GV2*.

(D7412GV2 is used as an example, other control panels could be D9412GV3/D9412GV2, D7412GV3, D7212GV3/D7212GV2.)

5.The display returns to idle text after 5 sec.

Service Menu (9 + 9 + Enter)

The service menu is used to access the following commands:

View Log - Use this function to review events in your system at your keypad. Reviewing past events might help you identify problems. Viewing events will not require any additional equipment since the information is shown at your keypad. Events are stored in the control panel’s memory in order of occurrence and tagged with the date and time.

Print Log - The Print Log function lets you print the events stored in your security system’s log. You can choose to print the entire log or set a start date and print the events recorded from that date up to today. Your system must include a parallel printer interface and a printer to perform this function.

Display Rev (COMMAND + 5 + 9) - The command retrieves the control panel’s software version and display it.

Service Walk (D9412/D9112 only) – The command allows all the points on the system to be walk tested regardless of the type of point. For D7412GV3/D7412GV2 and D7212GV3/D7212GV2 Control Panels this function must be added to the keypad’s menu. Contact your security company for more information.

Default Text – This command shows the current state of the area for 3 sec before returning to idle text.

Keypad Programming - This optional command is only included in this menu when enabled and when all areas are disarmed. Access is restricted to the Service User only. Through this menu, you can change a limited selection of system configuration parameters. Consult your security company for details.

Bosch Security Systems, Inc. 9/10 F01U169130-02 57