HP 625n Gigabit Ethernet Print Server Telnet Commands and Parameters 4, Wireless Diagnostics

Table 3.4 Telnet Commands and Parameters (4 of 18)

wpa-auth-type	This command is not compatible with the Shared Key
	authentication option in the auth-typecommand. Use this
	command to specify WPA-PSK authentication.
	PSK: WPA-PSK provides enhanced authentication where
	an authentication server is not used. Instead, a Pre-shared
	key provides device authentication. A Pre-shared key is
	generated when you specify a network pass-phrase using
	the psk-passphrase command. The dynamic-encrypt
	command should be set to the Robust option.
psk-passphrase	Specify a pass-phrase that is used to generate a network
	Pre-shared key. A pass-phrase must be from 8 to 63 ASCII
	characters in the hexadecimal range 21 through 7E
	(characters 0-9, a-z, A-Z and numerous special characters
	including !, @, #, $, %, ^, &, (, ), _, +, =, -, {, }, [, ], \, /, “, <,
	>, ?, “, ‘, ~).
dynamic-encrypt	For WPA-PSK authentication, use this command to set the
	print server for dynamic Wi-Fi Protected Access (WPA)
	encryption. Specify Robust as the command option.
802.11 Wireless Diagnostics
Command	Description
Current SSID	(Read-only parameter) The network name (SSID) to which
	the wireless print server connected.
Current Channel	(Read-only parameter) The channel that the wireless print
	server is currently using.
Signal Strength	(Read-only parameter) The strength of the radio signal
	received by the print server.
	<blank>: No radio signal detected while the print server is
	scanning.
	No Signal: No radio signal detected on any channel.
	Poor/Marginal/Good/Excellent: Indicates the detected
	signal strength level.
Access Point Mac	(Read-only parameter) The Media Access Control (MAC)
	address of the Access Point used for Infrastructure mode
	communications. For example,
	00:a0:f8:38:7a:f7
	specifies that the Access Point with MAC address
	00a0f8387af7 was used for communicating on the network.

ENWW TCP/IP Configuration 82