Status
The Status page displays the current security configuration settings of the print server. The settings that will be displayed depend on the features supported by the print server.
Wizard |
|
|
|
Note | If you use HP Web Jetadmin to manage your |
| devices, you should not use this wizard. Instead, use |
| HP Web Jetadmin to configure your network |
| security settings to ensure they are properly set for |
| your network. |
|
|
The Wizard page allows you to run the HP Jetdirect Security Configuration Wizard. This wizard will guide you through the print server’s security configuration needed for your network. Click Start Wizard to run the wizard. This opens the Security Level page.
The optional configuration parameters presented by the wizard will depend on your choice of security level. For an overview, see Table 4.11.
Note | If you improperly exit the wizard (for example, by |
| failing to use the Cancel button), an Operation |
| Failed screen may appear. If so, wait approximately |
| two minutes before entering the wizard again. |
|
|
Restore Defaults
This page is used to restore security configuration settings to factory defaults. The default settings displayed depend on the features supported by the print server.
Only the security settings listed are restored to factory defaults, other configuration settings are not affected.
ENWW | Using the Embedded Web Server 135 |
