HP 625n Gigabit Ethernet Print Server Configuration Page Messages, HP Jetdirect Configuration 1

Configuration Page Messages

HP Jetdirect Configuration/General Information

Information in this section provides general HP Jetdirect print server configuration as described in Table 9.1. For error messages, see Table 9.11.

Table 9.1	HP Jetdirect Configuration (1 of 2)
Message		Description
STATUS:		Current state of the HP Jetdirect print server.
		I/O CARD READY, or READY: The HP Jetdirect print server
		has successfully connected to the network and is awaiting
		data.
		I/O CARD INITIALIZING, or INITIALIZING: The
		HP Jetdirect print server is initializing the network protocols.
		For more information, see the status line for each protocol
		on the configuration page.
		I/O CARD NOT READY, or ERROR: There is a problem with
		the print server or its configuration.
		An error code and message is displayed if the print server
		is not ready. For more information, see Table 9.11.
MODEL NUMBER:		The model number of the HP Jetdirect print server (for
		example, J7951A)
HARDWARE		The 12-digit hexadecimal network hardware (MAC) address
ADDRESS:		of the HP Jetdirect print server installed in the printer or
		device. This address is assigned by the manufacturer.
FIRMWAREVERSION:		The firmware revision number of the HP Jetdirect print
		server currently installed in the printer.
NETWORK		(ew2400) Specifies the type of network connection:
CONNECTION TYPE		Wireless or Wired.
DATA RATE		(ew2400) Specifies the network data rate depending on the
DETECTED		type of network connection:
		1 - 54 Mbps (Wireless 802.11g)
		10 Mbs, 100 Mbps (Wired 10/100Base-TX)
LINK CONFIG		(ew2400) Specifies the active link communication mode:
		802.11: Wireless 802.11g
		10T HALF: 10 Mbps, half-duplex (wired port)
		10T FULL: 10 Mbps, full-duplex (wired port)
		100TX HALF: 100Mbps, half-duplex (wired port)
		100TX FULL: 100Mbps, full-duplex (wired port)

ENWW HP Jetdirect Configuration Page 205