JVC RX-888VBK manual Release VCR 1 Power, Try to operate your VCR by pressing VCR 1 Power

To change the transmittable signals for operating a CATV converter or DBS tuner

To change the transmittable signals for operating another manufacturer’s VCR

1.Set the remote control mode to “CATV/DBS.”

2.Press and hold TV/CATV/DBS POWER.

3.Press TV/DBS.

4.Enter manufacturer’s code (three digits) using

buttons 1–9, and 0.

See the list on page 49 to find the code.

Examples: For a JVC product, press 7, 7, then 5. For a Pioneer product, press 1, 4, then 4.

5. Release TV/CATV/DBS POWER.

After setting the remote control mode selector to “CATV/DBS,” you can perform the following operations on the CATV convertor or on the DBS tuner:

TV/CATV/DBS POWER: Turns on and off the CATV converter

	or DBS tuner.
CHANNEL +/–:	Changes the channels.
1 – 10, 0, 100+ (+10):	Selects the channel.
	100+ (+10) button will function as
	the ENTER button if your equipment
	requires pressing ENTER after
	selecting a channel number.

Note:

Refer to the manual supplied with your CATV converter or DBS

tuner.

6. Try to operate your CATV converter or DBS tuner by pressing TV/CATV/DBS POWER.

When your CATV converter or DBS tuner turns on or off, you have entered the correct code.

If there are more than one code listed for your brand of

CATV converter or DBS tuner, try each one until the correct one is entered.

1.Set the remote control mode to “AUDIO/TV/ VCR.”

2.Press and hold VCR 1 POWER.

3.Press VCR 1.

4.Enter manufacturer’s code (three digits) using

buttons 1–9, and 0.

See the list on pages 50 and 51 to find the code.

Examples: For a JVC product, press 0, 0, then 8. For a Funai product, press 0, 0, then 0.

5. Release VCR 1 POWER.

Following button can be used for operating the VCR (with the remote control mode selector set to “AUDIO/TV/VCR”):

VCR 1 POWER Turns on and off the VCR.

After pressing VCR 1 or VCR 1 CONTROL (with the remote control mode selector set to “AUDIO/TV/VCR”), you can perform the following operations on the VCR:

CHANNEL +/– Changes the TV channels on the VCR. 1 – 10, 0, 100+ (+10): Selects the TV channels.

	100+ (+10) button will function as
	the ENTER button if your VCR
	requires pressing ENTER after
	selecting a channel number.
PLAY:	Starts playback.
1:	Rewinds a video tape.
`:	Fast winds a video tape.
STOP:	Stops operation.
PAUSE:	Pauses.

ƒREC: Starts recording or enters recording pause.

Notes:

•Refer to the manual supplied with your VCR.

•You can use either VCR 1 button or the VCR 1 CONTROL button to activate the buttons listed above. If you press VCR 1, the playing source also changes. On the other hand, if you press VCR 1 CONTROL, the playing source does not change.

6.Try to operate your VCR by pressing VCR 1 POWER.

When your VCR turns on or off, you have entered the correct code.

If there are more than one code listed for your brand of

VCR, try each one until the correct one is entered.