Activating the DVD Multi Playback Mode

This receiver provides the DVD MULTI playback mode for reproducing the analog discrete output mode of the DVD player. Before playing back a DVD, refer also to the manual supplied with the DVD player.

IMPORTANT:

When using the remote control, check to see if its
remote control mode selector is set to the correct	AUDIO/
position:	TV/VCR
position:
To operate this receiver, set it to “AUDIO/TV/	CATV/DBS
VCR” (except when selecting the DBS tuner as
the source).

4.Adjust the center tone.

1)Press BALANCE/SURROUND ADJUST repeatedly until “CENTER TONE” appears on the display.

The display changes to show the current setting.

2)Turn MULTI JOG to select the center

BALANCE/SURROUND

ADJUST

MULTI JOG

Activating the DVD MULTI Playback Mode

You can adjust the DVD MULTI playback mode while playing back a DVD using the analog discrete output mode on the DVD player. Once you made adjustments, the receiver memorizes the adjustments until you change them. You also need to set the DVD player to the analog discrete output mode.

Before you start, remember...

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

On the front panel:

1. Turn SOURCE SELECTOR until	SOURCE SELECTOR
“DVD MULTI” appears on the
display.

Note:

When you select “DVD MULTI” as the source to play, the DSP mode is canceled temporarily, and the DOLBY/DTS SURROUND ON/OFF and DSP MODE buttons do not work.

tone level you want.

The center tone adjustment affects the mid-frequency range, which the human voice is mostly made up of.

•As you turn it, the display changes to show the following:

SOFT 2SOFT 1FLATSHARP 1SHARP 2

Adjusted levels are also shown on the equalizer display.

This CNTR means this adjustment can

S E A

CNTR be applied to the center speaker only.

(Example: When “FLAT” is selected.)

100 1k 10k

To make the dialogue clearer, select “SHARP 1” (little) or

“SHARP 2” (much).

To make the dialogue softer, select “SOFT 1” (little) or “SOFT 2” (much).

When “FLAT” is selected, no adjustment is applied.

2.Select the analog discrete output mode on the DVD player, and start playing a DVD.

• Refer to the manual supplied with the DVD player.

If you need to make any adjustment, go to the following steps.

3. Adjust the speaker output levels.

1)Press BALANCE/SURROUND ADJUST repeatedly until one of the indications appears on the display. “CENTER LEVEL”:

To adjust the center speaker level. “REAR L LEVEL”:

To adjust the left rear speaker level. “REAR R LEVEL”:

To adjust the right rear speaker level.

2)Turn MULTI JOG to adjust the selected speaker output level (from –10 dB to +10 dB).

3)Repeat 1) and 2) to adjust the other speaker output levels.