Pump / Drive Assembly Instructions
Install Front frame Rail Supports:
1. Remove Bolts from Tractor Frame Rails. Find the front most 4 Bolts in the Tractor Frame Rail, There are 4 on the RH side and 4 on the LH Side. DO NOT REMOVE THE BOLTS
FROM BOTH SIDES AT THE SAME TIME, ONLY do one side at a time the RH or the LH. For illustration start with the RH Side (See Figure 17). The RH & LH Frame Rail Supports have a Right and a Left. They will not inter- change and must be mounted on the correct side. Notice the way they are built, the Plate part that bolts to Tractor is longer in the front on both LH & RH. Make sure the longest part is to the front (See Figure 18).
2.Install Frame Rail Support RH Side. This works best with a 2 man team. The RH Frame Rail Support the is held on with the 5 bolts that Bolts that are supplied w/ mounting kit. Start all 5 bolts with Lockwasher before any of the 4 are tightened (See Figure 18). When tightened down it will look like the picture in Figure 18. Tighten the four retaining bolts for the RH Frame Rail Support before lossening or removeing the bolts on the LH side.
3.Install Frame Rail Support LH Side. Make sure that the bolts on the RH side have been tightened before removing the four bolts on the LH side. The LH Frame Rail Support will install the same as the RH side did. Remove the 4 bolts; Install the Front Frame Rail Support. Tighten the 4 bolts through Tractor Frame Rail. (See Figure 19).
Tractor Frame Rail |
Bolts(5) |
Figure 17 |
Right Hand Frame rail
Support Shown
Figure 18
| Mounting Plates on |
| Front Frame Rail |
| Support, the longer |
Figure 19 | part toward front on |
RH and LH side |
© 2003 | Alamo Group Inc. | Section 3 - 7 |
|
