Alamo DSEB-D16 Joystick Mounting 2 WD & 4 WD, InstallingJoystick to Bracket, Alamo Group Inc

Joystick Mounting 2 WD & 4 WD

InstallingJoystick to Bracket:

1.Bolt Joystick to Mounting Bracket. Set Joystick Assembly on Mounting Bracket. Make sure Joystick is mounted as shown, the Push Pull Switch in rear and Toggle Switch to the front. (See Figure 6)

2.Installing Joystick Mounting Bolts. Find the two 3/8" bolt, put Lockwasher and Flatwasher on them. Start these bolts from the bottom up through Bracket and into Joy- stick Console. The Joystick Console holes are threaded so no Nuts are needed. Tight- ened the two retaining Bolts (See Figure 1 Item 3 and Figure 2).

Installing Wiring Harness for Joystick:

1.It is recommended that the Wires for Joystick be connected at the Tractor Ignition Switch. But they can be connected as ex- plained below. If connected as shown below Wires must be traced to find the correct wires.

2.Preparing Tractor Floor Mat. First thing to do is remove the Battery Cables from Battery, Do Not perform any work on Tractor unless this has been done. Raise the Floor Mat up on the RH Side by the RH Door, You will need to fold it back approx. 12 to 14 inches (See Figure 8). DO NOT Tear or Cut any Holes in Floor Mat, as it will NOT be required. You will also find a large oblong shaped rub- ber plug, this will be pulled up later but it is not necessary at this time.

3.Tractor Wiring Harness. Under the Floor Mat on the right hand side you will find a Tractor Wiring Loom Running across Floor, remove the plastic cover that is over the wire loom. Using Tractor Manufacturers Service Manual Identify Which Wire is in this Loom.

FIGURE 6

FIGURE 7

Wire Cover

FIGURE 8

A-Boom (JD 6615 / 7615 Asy Instruction Manual) 07/03

© 2003 Alamo Group Inc. Section 9 - 4