Alamo DSEB-D16/SAS Assembly Tools, Supplies and Equipment Needed, Alamo Group Inc

Assembly

Tools, Supplies and Equipment Needed

Tools that are recommended to complete this assembly. There are number of different ways to do things, some items are recommended to make assembly easier but may not be required.

1.An over Head Hoist, the hoist (or Lift) should be a 2-1/2 ton capacity minimum. Hoist should be able to move and stop within fractions of an inch. Hoist should also have a 12 foot lift (Required).

2.Compressed Air, Air must be filtered and dry. A Safety air nozzle for blowing out Hoses and Fitting prior to assembly. (Required).

3.Complete Air Impact Sockets, 1/2" Drive and 3/4” drive (Recommended).

4.Torque Wrench, 400-ft lb. rating, can use a Torque Amplifier Wrench. (Required)

5.Complete Set of Hand Wrenches from 7/16" to 2" (Recommended).

6. Assortment of Screwdrivers, (Short ones and Long ones). (Required)

7.Electric Grinder or Air Grinder, Size according to needs (Required).

8.Burr Grinder, Electric or Air optional, for resizing Holes and removing Burrs from stamped metal or stamped holes. (Required)

9.Welder, capable of welding up to 3/8" material, Use experienced Welder Personel. (Required)

10.Flame Proof or flame retardant Material to Cover and protect Tractor finish and components during assembly. (Required)

11.A good fire Extinguisher on hand before any welding or grinding begins. (Required)

12.	Clean dust free work area, clean Lint Free towels or wipes. Do not do any welding, use
	compressed Air or lay out any component unless area is clean. Material the size of a human
	hair can contaminate the Hydraulic System (Required).

13.A place to keep all Components separate and clean untill ready for them (Recommended)

14.Electrical Butt connectors and Electrical Pliers. (Required)

15. Paint Scraper to remove Paint before welding. (Recommended)

16.Floor Jack, 2-1/2 Ton capacity (Required)

17.An asortment of large C-Clamps (Required)

A-Boom (JD 6615/ 7615 Asy Instruction Manual) 07/03
© 2003 Alamo Group Inc.	Section 1 -	2