Frame Rail Installation 4 WD
Re-Install High Frame to Tractor: (continued)
9.Frame Mount should look like. Shown below is basically what the High Frame should look like when assembled (See Figure 26).
Mounting Angle / Mounting | Bar Mounting Strap |
| |
Wleded to Frame |
| ||
Tube Bolts & Nuts |
| ||
|
| ||
Frame Rail | Mounting Tube | Approx 1/2" | |
|
| ||
|
|
| |
Mount |
|
| from end of |
|
| frame rail | |
Plate |
|
| |
|
|
| |
Bolts |
|
|
|
Front | Bar Mounting Straps |
| Tank |
Support |
| Mounting | |
with Bolts & Nuts |
| ||
Mount |
| Tubes | |
|
| ||
|
| Machete High Frame |
|
Figure 26 |
| Frame |
|
| Rail |
| |
|
|
| |
10.Tie Hoses to Tractor Frame Rail. Use Plastic Wire Ties to tie the Hoses and Cables from the rear of the Tractor down Frame Rails. Note: below it is shown with the Frame Rails not mounted to Tractor, this is done for illustration only (See Figure 27).
Inspect all the Hoses, Wire harness and Cables to make sure they are secured and will not be rubbed or chaffed on anything. Hoses and Wire harness should not be hanging down where they will be caught on anything. If there is excess length in hoses or wire harness, gather this ex- cess up under cab and secure it out of the way. There will most likely be excess length in these hoses and wire harness.
Figure 27
© 2003 Alamo Group Inc. | Section - 8 |
