
Wire Harness / Valve Mounting 2 WD & 4 WD
Installing Wire Harness
To Valve: (Continued)
5.Wire Harness Terminal Identification. The Wire Harness Terminal Plugs are marked in writ- ing on the plug. Swing, Lift, Dipper, Tilt and Door terminal plugs (5 Total). The Valve terminals are in this same order starting at the bottom and coming up on the valve. You will need to have a short handle Phillips screwdriver for this. (See Figure 26).
6.Wire Harness Terminal Installation. You will need to feed wire harness under the fitting across tank (See Figure 24) lay the Plugs out in the Order they are to be installed starting at the bottom terminal.
7.Terminal Connections. Make sure that each terminal Plug on Valve has had the Gasket in- stalled on it, then Install Swing Terminal and tighten Plug Retaining Screw. Continue this with all 5 plugs starting at the bottom and coming up (See Figure25)
| PLUG | FUNCTION |
1 | Bottom Plug | Swing Terminal |
2 | 2 nd Plug Up | Lift Terminal |
3 | 3 rd Plug Up | Dipper Terminal |
4 | 4 th Plug Up | Tilt Terminal |
5 | Top Plug | Door Terminal |
Connect and tighten all 5 terminal plugs one at a time till all 5 are connected. (See Figure 26)
Photo without Pump & Hoses
shown for illustration only
Door
Tilt
Dipper
Lift
Swing
FIGURE 25
Plug Gaskets
FIGURE 23
Terminal
Plugs
FIGURE 24
Short Handle
Phillips
Screwdriver
FIGURE 26
© 2003 | Alamo Group Inc. | Section 9 - 9 |
|