Alamo DSEB-D16 Frame Rail Installation 4 WD, Re-Install Frame Rails to Tractor continued, Gusset

Frame Rail Installation 4 WD

Re-Install Frame Rails to Tractor: (continued)

6. Install Stabilizer Crossmember. This will con-
sist of a Tube cross member and four Bolts and	RH Axle Strap
Nuts (See Figure 11). Install the Bolts with the
Nuts on Top and bolts coming in from the Bottom
(See Figure 12), this way only the Head of the Bolt
is lower than the Crossmember. Snug the Bolts; do
not tighten them yet.

7.Weld Stabilizer Gusset to Rail Stiffener Weldment. Weld the Gusset to the Stabilizer Weldment now, Weld on both sides of the Gusset. The LH Gusset and RH Gusset must be welded.

(See Figure 13). Check that all Bolts and Nuts	Figure 9
are installed.

Boom Rest
	Axle Strap Bolts
Figure 10	Figure 11

Install with Nuts on top and Bolt Heads on the bottom

Figure 12

Stabilizer
Gusset
	Weld Gusset to
	Stabilizer on both
Figure 13	sides.

A-Boom (JD 6615 / 7615 Asy Instruction Manual) 07/03

© 2003 Alamo Group Inc. Section 5 - 4