Alamo DSEB-D16/SAS instruction manual Drive Shaft Assembly

Pump / Drive Assembly Instructions

Installing Pump Drive

Components:

2.Access to Crankshaft Pulley. The Factory Crankshaft Pulley will not need to be removed. The Pulley Adapter will be bolted to the Factory Crank- shaft Pulley.

3.InstallPulleyAdapter.The Pulleyadapter to be used is a round plate with 4 threaded holes and four non-threaded holes in it. Notice this pulley adapter will not have a center hole in it (See Figure 4). The Non-treaded holes are used to mount the Adapter to the Pulley using bolts # 02979791 (10mm 1.5 P X 35mm Gr.10.9) & Lockwasher # 00755954 (10 mm). Do not use longer bolts to mount Pulley Adapter to Pulley than is supplied with mounting kit.

4.Driveshaft Assembly. The drive shaft is a two piece Assembly, an inner and outer shaft assembly (See Figure 5). The Shaft End has a four bolt flange yokes on it that connect to the Crankshaft Pulley Adapter. The Tube end has a splined clamp yoke on it that connects to the Pump. This Drive Shaft connects to the Pulley Adapter. Note that the Universals of the Driveshaft are in time. When installed in tractor they should be in time as shown, both Yokes the same.

4	4 Threaded
Non-Threaded
	Holes
Holes

Front Cover

Plastic Plugs

	Cover
	Retaining
Figure 2	Bolts (2)

Front Cover Removed

Pump Plate Mounting Holes

Figure 3

Splined Clamp Yoke

/ Tube End

Flange Yoke

/ Shaft End

Pulley Adapter

Part # 02979790

Figure 4

Drive Shaft

Assembly

Figure 5

A-Boom (JD 6615 / 7615 Asy Instruction Manual) 07/03

© 2003 Alamo Group Inc. Section 3 - 3