Alamo DSEB-D16/SAS Option Joystick Mounting, Installing Joystick Mount to Trac- tor Seat

Option Joystick Mounting

Installing Joystick Mount to Trac- tor Seat:

1.Remove Tractor Seat Cushion. Remove Lower Seat Cushion from Tractor Seat. The Seat Cushion should have three phillips head screws across the front edge (See Figure 2). Once these screws are removed, lift up on the front of the Seat Cushion which should slide forward and out.

2.Joystick Bracket mounting holes. The three mounting holes are already in the Standard Seat Mounting Plate. If a custom Seat or for some reason these three holes have to be drilled, use caution not to drill them in to where the bolts will interfere with the Tractor Seat Slide Adjustment Rail.

3.Bolt Mounting Bracket to Seat. Insert the three 5/16" Bolts with Flatwashers on them through the holes in the Seat Plate (See Figure 4). The Mounting Bracket is under the Seat Plate as shown in the drawing. Install the three 5/16" Lock- nuts on the Bolts from the Bottom. Tighten the three Bolts and nuts.

4.Re-install Tractor Seat Cushion. Re- install Tractor Seat Cushion in reverse of step 1. Test Seat to make Sure that it does not bind when slid forward or back as adjustment. If there is a Bind, check and correct problem.

FIGURE 2

FIGURE 3

FIGURE 4

FIGURE 5

A-Boom (JD 6615 / 7615 Asy Instruction Manual) 07/03

© 2003 Alamo Group Inc. Section 9 - 3