Alamo DSEB-D16/SAS Attaching Flail Head, Optional Mower Head Installation, Alamo Group Inc

Optional Mower Head Installation

Attaching Flail Head:

1.With a Forklift or Hoist, lower the boom Weldment on the Flail Head. Align the boom Weldment with the Mower Head Hitch Post. Insert special bolts (item 1 p/n 02956972 and item 2 p/n 00752405) into Boom Weldment and Hitch Post. Attach nuts (item 3 p/n 02030300 and item 4 p/n 00037200) to bolt and tighten securely. Note: Additional support may be needed at the end of the Boom to aid in installation.

2.Install Hoses Female - JX in position as shown, hand tighten. DO NOT start Tractor untill after filling Hyd Tank with Oil (See Filling Hyd Tank Section). Fully extend and retract tilt cylinder and insure hoses do not bind or kink then secure fittings. Tighten any leaking Hydraulic Fittings. If fluid still leaks, loosen the fitting, apply a pipe thread compound to the end threads and tighten (Do not allow Thread compond to get into Hydraulic system). Care must be taken when tightening, over tightening can cause the fittings to crack and require replacement fittings. Use recommened hose end and torque values found in chart in operators manual.

3.Warning, Escaping fluid under pressure can penetrate the skin causing serious injury. Re- lieve pressure before unhooking hydraulic or other lines. Tighten all connections before applying pressure. Keep hands and body away from pinholes and mozzles which eject fluids under high pressure. Use a piece of cardboard to search for leaks. If any fluid under pressure is injected into the skin, it must be surgically removed withing a few hours by a doctor familiar with this type injury or gangrene may result.

4.Hoses should not interfere with mower operation such as being pinched, kinked or entering the cutter housing. The hoses may be twisted slightly. To hold them up and/or inward tighten the fitting once the proper location is found.

*Note the position of hoses and fittings. It is important that they are installed as shown.

		Boom
					deg.
	02961074			45
			Boom
						02961074
View "A"
		02961074

Female - JX & Male

JX90 deg. Elbow

#02960407

15 deg.

02961074

View "A"

Figure 4

A-Boom (JD6615 / 7615 Asy Instruction Manual) 07/03

© 2003 Alamo Group Inc. Section 10 - 3