Alamo DSEB-D16 Re-Install Frame Rails to Tractor, Front Mounting Pads, Frame Rail Mounting

Frame Rail Installation

Re-Install Frame Rails to Tractor:

1.Re-Install Frame Rails. With the Welding done touch up or re-paint frame rails before re- installing them. The RH and the LH Rail will install to the Tractor the same except for the Boom rest that installs on the RH Rail Rear Mount. It is best to do the Left Hand Frame Rail first then the RH Rail. Use a Hoist to install Frame rails to Tractor. (See Figure 1).

2.Install the Bolts into the rear Axle Housing to support the rear of the frame rails. This is the same for LH & RH. Snug the Bolts only. Do not tighten them yet because the frame rails will have to be moved around to align all the Bolt Holes. (See Figure 56). The RH rear Frame Rail Mounting will need the Bolts removed to install the Axle Mounted Boom Rest (See figure 5, 6 & 7).

3.Install the Bolts into the front mounting Plates on the LH and RH Side. Snug them only.

(See Figure 3).

4.Install the LH Axle Straps. The LH Axle Strap can be installed now (See Figure 4). The Left Hand Axle Strap uses two long Bolts with Nuts. The Bolts go down through the Holes in the rear Axle Mounting Plate that is welded to the rear of the frame rail. Once the Rear Axle Strap is installed the Bolts for the LH Frame Rail and Axle Strap, snug the Bolts only, do not tightened them down (See Figure 1, 2, 3 & 4).

Front Mounting

Pads

Figure 3

Frame Rail

Mounting

Figure 1

Mounting to

Rear Axle

Figure 2

Rear Axle

Strap

Figure 4

A-Boom (JD 6615 / 7615 Asy Instruction Manual) 07/03

© 2003 Alamo Group Inc. Section 5 - 2