Alamo DSEB-D16/SAS Boom Installation / Boom Hoses, Attach Swing, Cylinder to King, Frame

Boom Installation

Boom Installation / Boom Hoses:

(continued)

4.Attach the Rod end of the Lift Cylinder

(7) to the Lift Section with Pin (8), Bolt (9) and Nut (10) (also see Parts Section on the Boom Assembly) (See Figure 3).

5.Attach the Swing Cylinder . The Swing Cylinder attaches to the King Post on the Rod End and to the High frame on the Butt end of cylinder, There are two holes on the High frame that cylinder can be connected to. The outer Hole is the one that cylinder pin should be put in for a rear swing A-Boom. A Forward Swing A-Boom is rare, majority wil be rear Swing (parks to the rear for Transport.) (See Figure

6& 7).

6.Leave Boom Supported by Hoist untill Boom is connected to King Post and all cylin- ders attached. (See Figure 3). The Boom will have to be lifted again when Head is installed. Do not lift Boom with Hoist if the Cylinder hoses are open, the Cylinders are built with the inter- nal components covered with Oil. If boom is raised by hoist while these hoses are discon- nected oil may be forced out of collapsing end of cylinder.

Boom

Retaining Pin

& Nut

Figure 4

Lifting Lugs weld on here

Figure 5

		Attach Swing	High Frame
			(Swing Cylinder Mount)
		Cylinder to King
			Front
		Post and High	Swing
		Frame	Hole
			Rear
			Swing
			Hole
			Swing Cylinder
			Butt End
	Figure 6		Figure 7
A-Boom (JD6615 / 7615 Asy Instruction Manual) 07/03
© 2003	Alamo Group Inc.	Section 7 - 3