Diagnostic Error Code | FRU/Action | |
|
|
|
1. | Press F3 to review the log file. | |
exceeded | 2. | Restart the test to reset the log file. |
| ||
|
| |
1. Make sure the component that is called out is | ||
|
| connected and/or enabled. See Chapter 6 “Using |
|
| the Setup Utility program” on page 39. |
| 2. | |
| 3. | Replace the component that is called out in warning |
|
| statement. |
| 4. | Replace the component under test. |
|
| |
1. If a component is called out, make sure it is | ||
|
| connected and/or enabled. See Chapter 6 “Using |
|
| the Setup Utility program” on page 39. |
| 2. | Flash the system and |
|
| (flashing) the BIOS” on page 165. |
| 3. | Go to “Undetermined problems” on page 67. |
|
| |
1. Go to “Undetermined problems” on page 67. | ||
| 2. | Flash the system and |
|
| (flashing) the BIOS” on page 165. |
| 3. | Replace component under function test. |
|
| |
No action | ||
|
| |
1. RAID signal cable | ||
| 2. | RAID device |
| 3. | RAID adapter card, if installed |
| 4. | System board |
|
| |
Information only Restart the test, if necessary. | ||
|
|
|
1. | Press F3 to review the log file. | |
exceeded | 2. | Restart the test to reset the log file. |
| ||
|
| |
1. Make sure the component that is called out is | ||
|
| connected and/or enabled. See Chapter 6 “Using |
|
| the Setup Utility program” on page 39. |
| 2. | |
| 3. | Replace the component that is called out in warning |
|
| statement. |
| 4. | Replace the component under test. |
|
| |
1. If a component is called out, make sure it is | ||
|
| connected and/or enabled. See Chapter 6 “Using |
|
| the Setup Utility program” on page 39. |
| 2. | Flash the system and |
|
| (flashing) the BIOS” on page 165. |
| 3. | Go to “Undetermined problems” on page 67. |
|
| |
1. See “Undetermined problems” on page 67. | ||
| 2. | Flash the system and |
|
| (flashing) the BIOS” on page 165. |
| 3. | Replace component under function test. |
|
| |
No action | ||
|
|
|
Chapter 8.