Lenovo 4219, 4220, 4222 Diagnostic Error Code, FRU/Action, XXX 014-014-XXX Parallel port Control

Diagnostic Error Code	FRU/Action
011-196-XXXSerial port test halt, error threshold exceeded	1.	Press F3 to review the log file.
	2.	Restart the test to reset the log file.
011-197-XXXSerial port test warning	1. Make sure the component that is called out is
		connected and/or enabled. See Chapter 6 “Using
		the Setup Utility program” on page 39.
	2.	Re-run test
	3.	Replace the component that is called out in warning
		statement.
	4.	Replace the component under test.
011-198-XXXSerial port test aborted	1. If a component is called out, make sure it is
		connected and/or enabled. See Chapter 6 “Using
		the Setup Utility program” on page 39.
	2.	Flash the system and re-test. See “Updating
		(flashing) the BIOS” on page 165.
	3.	Go to “Undetermined problems” on page 67.
011-199-XXXSerial port test failed, cause unknown	1. Go to “Undetermined problems” on page 67.
	2.	Flash the system and re-test. See “Updating
		(flashing) the BIOS” on page 165.
	3.	Replace component under function test.
011-2XX-XXXSerial port signal failure	1.	External serial device
	2.	System board
014-000-XXXParallel port Interface Test Passed	No action
014-001-XXXParallel port Presence	1. Remove external parallel device, if present.
	2.	Run the Setup Utility program, enable port
	3.	System board
014-002-XXX014-003-XXXParallel port Timeout/Parity	System board
error
014-013-XXX 014-014-XXX Parallel port Control	System board
Signal/Loopback test failure
014-015-XXXParallel port External Loopback failure	1. Wrap plug
	2.	System board
014-027-XXXParallel port Configuration/Setup error	1. Run the Setup Utility program, enable port
	2.	Flash the system. See “Updating (flashing) the
		BIOS” on page 165.
	3.	System board
014-03X-XXX 014-04X-XXX Parallel port failure	System board
014-195-XXXParallel port Test aborted by user	Information only Restart the test, if necessary.
014-196-XXXParallel port test halt, error threshold	1.	Press F3 to review the log file.
exceeded	2.	Restart the test to reset the log file.

52Hardware Maintenance Manual