Alamo DSEB-D16/SAS instruction manual Mounted the hole will be up. See Item

Frame Rail Installation

Tack Welding Frame Rails: (continued)

4.Frame Stiffener Assembly. The frame stiffener is an assembly designed to run under the Tractor to tie the two Frame Rails together and support each other. The Gusset Rail Support is designed to stabilize the Frame Rails to the tractor frame. Re-check the left hand and right hand sides to make sure the alignment is still correct and the tack Welding has been performed.

	Vertical Tube of RH Frame Rail
Front Wheel End	C-Clamp Here
		Rear Axle End
Tack Weld here on both		Horizontal Tube
sides Front and Back only		Gusset Rail Support
after alignment
Align Flush with Bottom		Tack Weld Here
		after final
of Vertical Tube		assembly only
RH Rail Stiffener Weldment (RH Side)
Rail Stiffener Tube Crossmember
		LH Frame Rail is
LH Rail Stiffener Weldment		Mounted Here
Figure 39	(LH Side)

5.Locate Mounting Tubes and Hardware. See Figure 31 for breakdown of these components.

A.There will be one Mounting Tube for each side; these tubes are the same so it will not matter which is on which side. The Mounting Tubes are the same on either end. (See

Figure 31 - Item 1).

B.There will be 8 Bar Mounting Straps (Part # 02966639); these straps are the same but later in the assembly process 2 will have to be cut (See Figure 31 - Item 2 & 2A).

C.	There are 2 Angle Mounts (Part # 02966641), these have two holes in them and when
	mounted the hole will be up. (See Figure 31 - Item 5).

D.There are 8 bolts (Part # 02957039) & Locknuts (Part # 00037200), the bolts are 3/4" X 10-1/2" Long (See Figure 31 - Item 4).

A-Boom (JD 6615 / 7615 Asy Instruction Manual) 07/03

© 2003 Alamo Group Inc. Section 4 - 18