Kicker DS680, DS460 manual DSCoaxialSpeaker, Application, Location, Dscoaxialspeaker, Owner’sManual

Stagger the holes for the wiring and use a rubber or plastic grommet to protect the wire from damage

Front Dash

Front Door

Body

DSCoaxialSpeaker

Owner’sManual

Models: DS350 / DS400 / DS460 / DS5250 / DS600 / DS650 / DS680 / DS6930

Door Body	Reinforcing Panel	Figure 2
	(Optional)
		Door Panel

Congratulations on your KICKER purchase

Please record your purchase

information and keep your sales receipt for validation of warranty.

Authorized Kicker Dealer:	_________________________
Purchase Date:	_________________________
Speaker Model Number:	_________________________

Speaker
cut-out
Speaker
cut-out	Coaxial Driver
	Speaker Grille
	Screws

Your DS coaxials were specially designed for “Livin’ Loud” out in the harsh automotive environment. They are made of advanced materials and construction techniques to maintain optimal performance for years to come.

Application

The Kicker DS coaxial speakers are specifically designed for mounting in free-air applications. The speakers do not require a sealed enclosure for optimum performance. It is important to isolate the sound coming off the front of the driver from the sound radiating from the back of the driver. This isolation is usually accomplished by using the driver in a factory speaker location, or in a location with a semi-isolated rear chamber. See Figure 1.

Figure 1

Place Speaker Grille over the Coaxial Driver

and mount with the enclosed Screws

INSTALLATION

Mounting

If you are replacing factory speakers in their original locations, you may have to enlarge the speaker cut-outs and pre-drill new screw holes using a 7/64” (2.5mm) bit. Custom mounting locations will require more preparation and work. In either case, make sure the speaker will not interfere with the trunk and door opening and closing mechanisms, and the enclosed screws will not puncture the fuel tank, wiring, or interfere with any other mechanical parts on the underside of the mounting surface. Cycle the windows all the way down and up.

If the speaker cut-out locations require you to cut metal, avoid structural metal and braces. If the door body and panel cannot support the weight of the speaker, an optional reinforcing

INSTALLATION

Trunk / Storage Space

Front Sound

Waves

Rear Sound

panel (thin piece of wood or Medium Density Fiberboard) may be sandwiched between the panels. Mount the speaker to the vehicle as outlined in Figure 2.

If factory speaker wiring is not available in your desired location, it may be necessary to run the supplied wire through the door jamb. The speaker wire should be kept away from sharp edges and avoid the possibility of getting pinched by the door. An existing grommet in the door jamb is the ideal place to run the speaker wire. If the factory hole and grommet do not exist or are inaccessible, you must drill a hole

Waves

Rear Seat

to run the speaker wire through the door jam. Be careful not to drill into other wiring or exiting door mechanisms. Any time a wire is run through a hole, it is necessary to insert a rubber or plastic grommet to protect the wire from damage as outlined in Figure 3.

Location

The sound produced by the DS coaxials is directional. Find the best location for stereophonic sound. If necessary, add more DS coaxial speakers to the system to help distribute and balance the sound. After determining the best mounting locations, carefully check the areas where the mounting hardware will be placed. See Figure 2.

Please allow two weeks of break-in time for the speaker to reach optimum performance.

If the supplied hardware is not applicable to your installation, some other means of securely attaching the speakers to the vehicle must be used.

Kick Panel	To the
Speaker	amplifier
	or source
cut-out	unit

Figure 3

2 DSCOAXIALSPEAKER 3