Kicker 10IX500.4 manual Model External Fuse Power/Ground Wire Kicker Wiring Kit

Wiring: Disconnect the vehicle’s battery to avoid an electrical short. Then, connect the ground wire to the amplifi er. Make the ground wire short, 24” (60cm) or less, and connect it to a paint-and-corrosion-free, solid, metal area of the vehicle’s chassis. Adding an additional ground wire of this same gauge (or larger) between the battery’s negative post and the vehicle chassis is recommended.

The IX amplifi er has dual input sensitivity differential RCA inputs which will receive either high or low level signals from your car stereo’s source unit. Ideally, when connecting the source unit to the amplifi er, the IX amplifi er’s input level switch should be set to “LO” and a low-level signal should run from the source unit’s stereo RCA output to the stereo RCA input on the end panel of the amplifi er using RCA interconnect cable. If a low-level stereo RCA output is not available on the source unit, the signal can be delivered to the amplifi er using the high-level speaker outputs on the source unit. Set the input level switch on the end panel of the amplifi er to “HI”. Crimp and solder RCA connectors to the end of the speaker wire running from the high-level speaker outputs on the source unit and connect the wire to the RCA Inputs on the end panel of the amplifi er or simplify the installation by using a KICKER ZISL as shown below. Either input method will provide a low-level output signal at the RCA output, which effectively passes the audio signal to another amplifi er or component. Keep the audio signal cable away from factory wiring harnesses and other power wiring. If you need to cross this wiring, cross it at a 90 degree angle.

source unit	core conductor	to amplifi er	KICKER ZISL
high-level speaker
outputs
+		OR	to amplifi er
–	shield		source unit high-level
			speaker outputs

Install a fuse within 18” (45cm) of the battery and in-line with the power cable connected to your amplifi er. Install a second fuse within 18” (45cm) of the amplifi er. If you ever need to remove the amplifi er from the vehicle after it has been installed, the ground wire should be the last wire disconnected from the amplifi er--just the opposite as when you installed it.

Model	External Fuse	Power/Ground Wire	KICKER Wiring Kit
	(sold separately)
IX500.4	2 x 50 Ampere	4 Gauge	PK4, CK4, ZCK4

					remote turn-on
					(see page 5)
AMP1			POWER		AMP1	AMP2 OUTPUT			AUTO	AMP2
								TURN ON
L+ L– R+	R–	GND	REM	+12V						L– R+	R–
									L+
						L	12V		DC AUDIO
								OFFSET
							FADER INPUT
									LEVEL
						R
BRIDGED							OFF		LO	BRIDGED
							ON		HI
≤24”											≤18”
(60cm)					external fuse
											(45cm)

bare-metal	external fuse	12V
chassis ground
		battery

3

2010 IX 500.4 RevB.indd 3

11/12/2009 2:16:38 PM