Miller Electric UWF-SC12RC manual Connecting Weld Cable, Installing And Threading Welding Wire

3-9. Connecting Weld Cable

From Wire Feeder

1 2

3

3-10. Installing And Threading Welding Wire

Hold wire tightly to keep it from unraveling.

3

1 2

6 in (150 mm)

Pull and hold wire; cut off end.

1 User-Suppled Weld Cable

Follow wire manufacturer’s recom- mendations for weld cable polarity.

2User-Suppled Male Connector

3User-Suppled Female Connector

Push female connector over male connector, and turn 1/4 turn clock- wise.

804 211-A

Installing Wire And Adjusting Hub Tension:

1Retaining Nut

2Hub Tension Adjustment Screw

Remove retaining ring, and install spool so hub pin fits spool hole. Re- install retaining nut.

Adjust tension nut so only a slight force is needed to turn spool.

Threading Welding Wire:

3Pressure Assembly Adjustment Knob

Lay gun cable out straight.

Open pressure assembly, hold wire tightly, and cut off end. Push wire through guides into gun.

Close and tighten pressure assem- bly. Press Jog switch until wire comes out gun.

Feed wire against wooden surface, and tighten knob so wire does not slip.

Cut off wire, and close door.

Tighten	Tools Needed:
Clockwise
	9/16 in

WOOD

804 212-A

OM-215 092 Page 11