SECTION 4 − OPERATION
4-1. Controls
2
3 | OFF | 1 |
| ON |
|
PURGE 
POWER
4
5
67
VOLTAGE WIRE SPEED
Front Panel
8
JOG 
Internal Control Panel
1Power Control Switch
2Trigger Hold Switch (Optional)
Depress the upper part of the switch (turns trigger hold On) to weld without holding gun trigger throughout the weld cycle.
To start weld, press and release gun trigger. To end weld, press and re- lease gun trigger.
Depress the lower part of the trigger hold switch to turn trigger hold Off.
3 Purge Switch
Press switch to momentarily energize gas solenoid and purge air from gun, and to adjust shielding gas regulator.
4Meter Display (Optional)
5Volts, Wire Feed Speed Or Amps Select Switch (Optional)
.Meter is factory set to display voltage and wirefeed speed. To display voltage and amps refer to Section
6Voltage Control
7Wire Speed Control
Use control to adjust wire speed with- in range selected by switch.
8 Jog Switch
Use Jog position to momentarily feed welding wire at speed set on Wire Speed control without energizing welding circuit or shielding gas valve.
Close and latch door.
Internal Side View
804
