Carbon Monoxide Alarm Features
CAUTION: This alarm will only indicate the presence of carbon monoxide gas at the sensor. Carbon monoxide gas may be present in other areas.
Individuals with medical problems may consider using warning devices which provide audible and visual signals for carbon monoxide concentrations under 30 ppm.
Operating/Installation Instructions
Step 1
Installing Batteries:
Batteries were not installed at the factory and must be installed for the unit to operate! Install the three (3) AA batteries in the back of the Smoke/CO Alarm.
•The mounting plate must be removed from the back of the unit to install batteries. To remove, hold the mounting plate and twist counterclockwise (left).
•The battery polarity markings on the bottom of the battery compartment must be adhered to.
•Batteries must be installed in the sequence shown. If batteries seem difficult to install, they’re not being installed in the proper sequence.
Batteries Must Be Installed in Order Shown Below:
3.Install Last
2.Install Second
1.Install First
INST ALL | |||
THIRD | |||
| 2 |
| INST ALL |
| SECOND | ||
| |||
ARNING:WBATTERIESHAVEBEENAAREMOVED | 1 |
| INST ALL |
| FIRST | ||
| |||
WARNING: | + | 3 | |
+ | 2 | ||
BATTERIES | |||
|
| ||
MISSING | + | 1 |
10
