Kingston Technology KND2415TX manual Stack-In / Stack-Out Ports, Stacking Conguration

Hardware Installation 7

Stack-In / Stack-Out Ports

Fig. 3-4 Stacking Conguration

The Fast EtheRx stackable hub uses stacking ports located on the back of the unit to stack up to a maximum of four hubs.

IMPORTANT: The KND2415TX can only be stacked with other KND2415TX units. Stacking the unit with any other model hub may cause damage to the units.

Follow the directions below on stacking these hubs together:

1.Power down the Fast EtheRx hub(s).

2.Locate the 50-pin shielded stacking cable included with your package contents.

3.Plug one end of the cable into the port labeled, “Stack-Out” on the rst hub.

4.Plug the other end of the cable into the “Stack-In” port on the second hub.

5.Repeat steps 2 through 4 for stacking up to a maximum of four (4) hubs.

Kingston’s Stack-n-Play™ feature offers greater scalabilty to add UTP ports without the need to congure ID or termination switches. When congured as a stack, the Fast EtheRx stackable hubs are recognized as a single unit on the network. By stacking hubs together, you can expand the total number of UTP ports up to 96 ports.

KND2415TX Users Guide - Rev. A00 Kingston Technology Company