Kingston Technology KND2415TX manual 10/100TX UTP Ports, Uplink Port, 2 Rear Panel

Hardware Installation 5

4.Make sure the cable is wired properly and connected on both ends.

5.If steps 1 through 4 are correct, the cable may be defective or not wired correctly. Please refer to Appendix A for pin assignments and Appendix B for cabling guidelines.

10/100TX UTP Ports

The twenty-four (24) 10/100TX UTP ports auto-negotiate both 10BASE-T and 100BASE-TX connections. . All ports like all normal hub ports are congured as MDI-X. However, port 24, supports both MDI-X and MDI port conguration.

Uplink Port

The uplink port provides cabling exibility on UTP port 24 for connecting to a workstation NIC or cascading to another hub. Although these ports have two (2) UTP connections, MDI and MDI-X, only one port may be used.

Notes on MDI and MDI-X Ports

MDI (Media Dependent Interface) is the standard that denes the mechanical and electrical conguration of a UTP port. For any two devices to communicate with each other, the transmitter of one device must be connected to the receiver of the other device.

Table 3-1MDI & MDI-X Conguration

Rear Panel

Power

AC Power Switch

Connector

U S E O N L Y W I T H A 2 5 0 V F U S E

Stack-in /Stack-Out Ports Fan Fuse (250V, 2A)

Fig. 3-2 Rear Panel

KND2415TX Users Guide - Rev. A00 Kingston Technology Company