KitchenAid 3182137 Before you start, Tools needed for installation, Panel A, 30” Single oven

30” Single oven

I-w--q-

t-i-

I

00 Not seal oven to cabinets.

I II

2-112’ min. See Note.*

rI II

*Note: There must be 1’ min. between bottom of cabinet door and top of oven console.

Oven control

_____,_

===+3!.,6”-

-.-.m.-

See Note.*

Before you start...

Read the electrical and carpentry instructions.

Proper installation is your responsibility. A qualified technician should install this oven. Make sure you have everything necessary for correct installation. It is the responsibility of the installer to comply with the installation clearances specified on the seriaVrating plate. The serial/rating plate can be found behind the oven door (double oven models - upper oven) on the frame of the oven. Check location where the built-in oven will be installed. The location should be away from strong draft areas, such as windows, doors, and strong heating vents. The built-in oven should be located for convenient use in the kitchen.

Cabinet opening dimensions that are shown must be used. Dimensions given are for a built-in oven sitting on a contact surface 2-314” below the open oven door height. The contact surface must be solid and level and flush with the bottom of the cabinet opening.

The recessed installation area must provide complete enclosure around the recessed portion of the oven.

ALL OPENINGS IN THE WALL OR FLOOR WHERE THE BUILT-IN OVEN IS TO BE

Ill	32’	min.	recommended
	so	oven	door, when

open, is 36’ from floor.

30” Double oven

I I I I

’

1

INSTALLED MUST BE SEALED.

Electrical ground is required. See “Electrical requirements.”

Do Not install single oven in a base cabinet with a countertop above it.

IThe oven support surface must be flush with the bottom of the cabinet opening.

Important: Observe all governing codes ordinances.

Electrical Shock Hazard lt is the customer’s responsibility:

l To contact a qualified electrical installer.

l To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSUNFPA

70 - latest edition**, and all local codes and ordinances.

Failure to do so could result in fire, electrical shock or other personal injury.

w;

	*Note: There must be 1’
	min.	between bottom of
2-W” min.	cabinet door and top of
	oven	console.
.

Oven control console

Note

Personal Injury Hazard Securely fasten oven to cabinet using the screws 4 screws provided (8 screws for double oven).

Failure to do so could cause the oven to move or tip during use and result in personal injury.

I

66&6’ 1

opening I

height I

;’

II

667;16”- recessed oven height

00 Not seal oven to cabinets.

recommended so upper oven door, when open is 36”

Tools needed for installation:

68-Y8’ - overall height

II See, Note:

Darts supplied for nstallation:

rews (single crews (doub 1e)

Panel A