12
7. Remove any rough edges by sanding smooth.
8. Partially open bottom drawer. Position toe panel behind door
and slide onto the underside of tub.
9. Close the drawer. Check that there is ¹⁄₂"
(12.7 mm) minimum clearance between
the bottom edge of the toe panel and
the floor.
If not, remove the toe panel and shorten
using the utility knife. Remove any rough
edges.
10. Slide toe panel back onto mounting rails.
11. If needed, you may simply push the toe panel back or forward
on the mounting rail.
12. With a Phillips screwdriver, tighten the toe panel clamping
screws on both sides.
13. Plug in dishwasher or reconnect power.
14. Go to “Complete Installation” section.
toe panel
mounting rail clamping
screw
¹⁄₂"
(12.7 mm)
floor
Option 1: Install standard toe panel
NOTES: Depending on countertop height, you may not have to
trim the toe panel.
Rugs placed in front of dishwasher could interfere with
toe panel. Clearance between floor and toe panel may
need to include the rug thickness.
1. Partially open the bottom drawer.
2. Turn the toe panel upside down and hold vertically against the
bottom edge of the tub side (not the front).
3. On the toe panel, mark where the tub���s bottom edge is.
4. On a stable surface, place toe panel on a wooden cutting
board and pick the closest groove to the mark. If the mark is
between two grooves, choose the groove that makes the toe
panel the shortest.
5. At the selected groove, use a utility
knife and cut the vertical rib the
length of the toe panel until entire
piece is removed.
6. Snap off the toe panel tabs.
bottom edge
of tub side
rear of
toe panel
toe panel
tab
toe panel
tab