KitchenAid 5KICA0WH Assembling the Ice Cream Maker Attachment for Bowl-Lift Mixer, English, Motor

Assembling the Ice Cream Maker Attachment

for Bowl-Lift Mixer*

English

To Attach Drive Assembly:

1.Be sure the speed-control is still on “O” (off) and the mixer is unplugged.

2.Make sure the bowl-lift handle is still in the down position, and the freeze bowl and dasher are in place.

3.Determine your mixer model by checking for a spring on the beater shaft, then position the drive assembly as illustrated for proper placement.

5.Raise the bowl to engage the dasher with the drive assembly before mixing. If the drive assembly doesn’t engage the dasher, slide the drive assembly either back or forward until it does engage the dasher properly.

Wider End

(marked “A”)

No Step

Spring

Narrower

End

(marked “B”)

Step

No Spring

4.Slide drive assembly onto the motor head until it will not slide any further. When properly assembled, the outer curved edges of the drive assembly should center on the motor head. If they are not centered, slide the drive assembly either back or forward until it is centered on the motor head. Make sure the drive assembly is securely in place by pressing upward.

6.Plug the mixer into a grounded 3-prong outlet.

	MOTOR
BEATER	HEAD
SHAFT

NOTE: If drive assembly will not fit onto the motor head, try using the other side of the drive assembly.

* For tilt-head mixer, see page 3 and 4.

6