KitchenAid 9741183 If dishwasher does not operate, If you need assistance, If you need service

Models: 9741183

1 7
Download 7 pages 3.51 Kb
Page 6
Image 6
If dishwasher does not operate...

Personal Injury/Property Damage

Hazard

Wear gloves and handle metal edges of panels carefully.

Cut metal edges are sharp and may cause personal injury or damage to other materials.

“$ -2

iL LRemove the newspaper protecting the pump. If color of door panel is to be changed or custom panels installed, change panels now. See Use and Care Guide for instructions.

P G&BCheck dishwasher door for proper operation. Door should close easily without slamming and should not fall open or shut from its own weight.

If door closes from an open position, adjust door spring brackets upward to a different hole.

If door falls open too quickly, move spring bracket downward.

If custom door panels weigh more than 4 pounds, install heavy-duty door springs.

s%

>~

 

a:8 a Make electrical

connection. See

“Electrical connection,”

Panel B. CHECK

ELECTRICAL REQUIREMENTS. BE SURE

YOU HAVE CORRECT ELECTRICAL SUPPLY

AND RECOMMENDED

GROUNDING

METHOD. Check that all parts have been installed and no steps were skipped. Check that no screws have fallen into the tub. Reinstall rack in dishwasher. Turn on electrical and water supplies.

3 a@:c

g ~~~~Start dishwasher on full wash cycle. Allow it to run 5 minutes. Check that dishwasher is working properly and that there are no leaks. Open dishwasher door to stop cycle. Check that water inside dish- washer is warm. Close dishwasher door and press “CANCEL/DRAIN”. When dishwasher stops, open door and check for proper draining.

,m.”f: *.

;y*,:;;iInstall top of access panel into channel and rotate panel towards dish- washer. Reattach the access panel with two screws. Check that the opening at the bottom of access panel is clear so air can circulate to cool motor.

If dishwasher does not operate...

Check that:

l the circuit breaker is not tripped or the house fuse blown.

l dishwasher door is closed tightly and latched securely.

l dishwasher rack is in place.

l dishwasher cycle has been set correctly. l water has been turned on.

l electrical power has not been interrupted.

Note: If the motor has stopped because of overload, it will automatically reset itself within a few minutes. A detailed troubleshooting checklist is provided in the Use and Care Guide.

If you need assistance...

The KitchenAid Consumer Assistance Center will answer any questions about operating or maintaining your dishwasher not covered in the Installation Instructions. The KitchenAid Consumer Assistance Center is open 24 hours a day, 7 days a week. Just dial 1-800-422-l 230 - the call is free.

When you call, you will need the dishwasher model number and serial number. Both numbers can be found on the serial/rating plate located on tub behind door.

If you need service...

In the event that your KitchenAid appliance should need service, call the dealer from whom you purchased the appliance or a KitchenAid-authorized service company. A KitchenAid-authorized service company is listed in the Yellow Pages of your telephone directory under “Appliances - Household

-Major - Service or Repair”. You can also obtain the service company’s name and telephone number by dialing, free, within the continental United States, the KitchenAid Consumer Assistance Center telephone number, 1-800-422-l 230. A special operator will tell you the name and number of your nearest KitchenAid- authorized service company.

Maintain the quality built into your KitchenAid appliance - call a KitchenAid- authorized service company.

Panel E

Page 6
Image 6
KitchenAid 9741183 If dishwasher does not operate, If you need assistance, If you need service, Panel E