Cutout Dimensions
3" (7.6 cm)
A
34¹⁄₄" min.
(87 cm)
24" min.
(61 cm)
18" min. (45.7 cm)
15¹⁄₄" min.
(38.7 cm)
A. Grounded eletrical outlet must be a minimum of 3" (7.6 cm) away from surrounding cabinets or nearby walls as shown. It can be placed either to the left or the right side of the compactor.
Clearance Dimensions
A
B
A. Leave 6" (15.2 cm) of clearance space to the right side of the compactor in order to remove the compactor bags.
B. Leave 23" (58.4 cm) of clearance in front of the compactor in order to fully open or remove the compactor drawer.
Electrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
Recommended Grounding Method
This compactor is for use on a single phase,
This compactor must be grounded while in use to reduce the risk of electric shock. The compactor is equipped with a three- conductor cord and 3 prong
UndercounterInstallation
NOTE: Proper installation is your responsibility. Make sure you have everything necessary for correct installation. It is the personal responsibility and obligation of the customer to contact a qualified installer to assure that electrical installation meets all National and Local codes and ordinances.
Tools and materials needed for installation:
■ | Level | ■ Phillips No. 2 screwdriver | |
■ | Tape measure | ■ | |
■ | Pliers | ■ | ⁵⁄₁₆" |
■ | Scissors | ■ | Utility knife |
IMPORTANT:
■Do not grasp control panel to move compactor.
■Slide compactor onto cardboard or hardboard before moving compactor across floor to prevent floor covering damage.
■Do not allow the rear frame of the compactor to touch the floor covering when lifting or moving compactor.
5