INSTALLATION REQUIREMENTS
ToolsandParts
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
ProductDimensions
A
Tools Needed
■Tape measure
■Small,
■
■#2 and #3 Phillips screwdriver
■Level
■Wrench or pliers
■Pipe wrench
■Noncorrosive leak detection solution
Parts Needed
■Gas line shutoff valve
■½" male pipe thread nipple for connection to pressure regulator
■LP
■CSA
Parts Supplied
■Convertible regulator set for 4" WCP Natural gas.
■
LocationRequirements
Select a location that provides minimum exposure to wind and traffic paths. The location should be away from strong draft areas.
Do not obstruct flow of combustion and ventilation air.
Clearance to combustible construction for
■A minimum of 24" (58 cm) must be maintained between the sides and back and any combustible construction.
■A 24" (58 cm) minimum clearance must also be maintained below the cooking surface and any combustible construction.
Ignition
A grounded, 3 prong outlet located to the left of the sear burner is required. See “Electrical Requirements” section.
B
C
D
E
F
G
|
|
|
|
|
|
|
|
|
|
| H |
|
|
|
|
|
|
| ||
A. 13" | (33 cm) |
| E. 25³⁄₈" (64.5 cm) | |||
B. 12³⁄₄" (32.4 cm) |
| F. Manifold pipe | ||||
C. 17" | (43.2 cm) |
| G. 2¹⁄₂" (6.4 cm) | |||
D. 26³⁄₈" (67 cm) |
| H. 22³⁄₄" (57.8 cm) |
Built-In Outdoor Sear Burner Enclosure
The enclosure for the
CabinetDimensions
Enclosure and clearance dimensions that are shown must be used. Given dimensions provide required clearances.
Counter or support surfaces must be level.
The installation of this sear burner must conform with local codes or, in the absence of local codes, with either the National Fuel Gas Code, ANSI Z223.1/NPFA 54, Natural Gas and Propane Installation Code, CSA B149.1, or Propane Storage and Handling Code, B149.2.
Copies of the standards listed may be obtained from: CSA International
8501 East Pleasant Valley Rd.
Cleveland, Ohio
NOTE: The outdoor sear burner drops into the enclosure opening and is supported by its side flanges. No bottom support is needed.
5