KitchenAid KBGS274SSS0 installation instructions Installation Requirements, Tools and Parts

If the following information is not followed exactly, a fire causing death or serious injury may occur.

•Do not store a spare LP-gas cylinder under or near this grill.

•Never fill the cylinder beyond 80 percent full.

IMPORTANT: This grill is manufactured for outdoor use only. For grills that are to be used at elevations above 2000 feet, orifice conversion is required. See “Gas supply requirements” section.

It is the responsibility of the installer to comply with the minimum installation clearances specified on the model/serial rating plate. The model/serial rating plate can be found on the heat shield behind control panel.

Copies of the standards listed may be obtained from:

National Fire Protection Association

One Batterymarch Park

Quincy, Massachusetts 02269

CSA International

8501 East Pleasant Valley Rd.

Cleveland, Ohio 44131-5575

The California Safe Drinking Water and Toxic Enforcement Act requires the Governor of California to publish a list of substances known to the State of California to cause cancer, birth defects, or other reproductive harm, and requires businesses to warn of potential exposure to such substances.

WARNING: This product contains a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.

This appliance can cause low-level exposure to some of the substances listed, including benzene, crystalline silica, carbon monoxide, toluene, and soot.

In the State of Massachusetts, the following installation instructions apply:

•Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by the State of Massachusetts.

•If using a ball valve, it shall be a

T-handle type.

•A flexible gas connector, when used, must not exceed 3 feet.

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.

Tools needed for built-in outdoor grill combustible construction installations:

•Level

•Small, flat-blade screwdriver

•Flat-blade screwdriver

•Phillips screwdriver

•Tape measure or ruler

•Slip-joint pliers

•Pipe wrench

•Scissors or cutting pliers to remove tiedowns

Materials required for built-in outdoor grill combustible construction installation:

•Gas line shutoff valve

•1/2” male pipe thread nipple for connection to pressure regulator

•L.P. gas-resistant pipe-joint compound

•CSA design-certified flexible stainless steel appliance connector [4-5 ft. (1.2-1.5 m)] or rigid gas supply line as needed

•Noncorrosive leak detection solution

Parts supplied for built-in outdoor grill combustible construction installation:

•Convertible regulator set for 4” W.C. natural gas.

•2 single-prong plugs / transformer assemblies.

•Rotisserie motor.

•Rotisserie forks.

•Rotisserie spit and handle.

•Insulated jacket.

Parts needed for built-in outdoor grill combustible construction installation:

The built-in outdoor grills are manufactured for use with natural gas.

To convert to L.P./propane gas, Gas Conversion Kit no. 4396311 must be used. Follow Instructions included with kit.

4