To Use:
1.Push in and turn control knob to the SLOW COOK zone and set the desired temperature, LO or HI. Preheating is not necessary.
2.Place food into warming drawer. Food should be placed directly on the bottom of the warming drawer. Do not use the rack.
3.Close the warming drawer. Be sure that the warming drawer is completely closed during operation.
4.Turn control knob to OFF when finished.
Panel Kits
(Accessory)
Panel kits are available for customizing the front of the warming drawer to match other KitchenAid® home appliances. See the “Assistance or Service” section to order.
WARMING DRAWER CARE
Drawer Slides
The drawer slides allow you to fully extend the drawer for easier cleaning. If necessary, the drawer can be removed.
NOTE: Load capacity for the drawer is 100 lbs (45 kg).
Warming Drawer
Remove all items from inside the warming drawer, and allow the warming drawer to cool completely before attempting to remove the drawer.
To Remove:
1.Open drawer to its fully open position.
2.Locate the black tabs on both sides of the drawer.
A
A. Tab
3.Press the tab down on the right side of the drawer and lift tab up on the left side of the drawer at the same time. Then pull drawer out another inch to disengage latch.
4.Hold the drawer by the sides (not by the front). Pull it slowly all the way out.
To Replace:
1.Align the drawer rails with the receiving slides.
B
A
A. Drawer rail
B. Drawer slide
2.Push drawer in all the way.
3.Gently open and close the drawer to ensure it is seated properly on the slides.
GeneralCleaning
IMPORTANT: Before cleaning, make sure all controls are off and the warming drawer and the drawer accessories are cool. Always follow label instructions on cleaning products.
Soap, water and a soft cloth or sponge are suggested first unless otherwise noted.
STAINLESS STEEL SURFACES
To avoid damage to stainless steel surfaces, do not use soap- filled scouring pads, abrasive cleaners, Cooktop Polishing Creme,
Rub in direction of grain to avoid damaging.
Cleaning Method:
■KitchenAid® Stainless Steel Cleaner and Polish Part Number
4396920 (not included):
See “Assistance or Service” section to order.
■Liquid detergent or
Rinse with clean water and dry with soft,
■Vinegar for hard water spots
CONTROL KNOB
Do not use steel wool, abrasive cleansers or oven cleaner.
Do not soak knob.
When replacing knob, make sure knob is in the OFF position.
Cleaning Method:
■Soap and water:
Pull knob straight away from control panel to remove. Wash, rinse and dry with a soft cloth.
7
