Assembly

Vermont Castings Intrepid Multi-Fuel

Assembly

Clean the Griddle Before Use

At the factory we coat the griddle with vegetable oil to prevent rusting while the stove is in transit and storage. Remove the oil with a dry rag or paper towel before you use the stove.

Set Up the Stove

Remove the griddle, front grate bar, the bottom grate, the side bricks, and the ash pan from inside the stove. Place a protective pad on the floor, arrange some sec- tions of 4 x 4 lumber on the pad for support, and care- fully tip the stove back onto them.

Remove and discard the four large slot-head screws from the stove bottom (Fig. 12) and install the stove legs, using the hex head bolts from the parts bag.

Use 11 mm (3/8”) washers with three of the legs; the door/damper handle holder installs in place of a washer on the right front leg. Position the holder so the hole to accept the handle nub faces out from the right side of the stove. Tighten the bolts firmly.

Slotted

 

Screws

 

ST513

Fig. 12

Remove the slotted screws from the stove bottom.

Install the Bottom Heat Shield

To install the bottom heat shield, loosen the leg bolts, and slip the bottom heat shield C-clips onto the bolts. Orient the heat shield so that the longest 273 mm /

10³⁄₄”) edge is at the front of the stove. (Fig. 13) Attach the heat shield to the C-clips with the wing nuts and then tighten the leg bolts.

Storing the Handle

Use the removable handle to open or close the front doors, or to change the position of the damper. After use, remove the handle so it will not get hot, and store it in the handle holder installed behind the right front leg. (Fig. 14)

2000970

10³⁄"

9³⁄"

ST512

Fig. 13 Attach bottom heat shield.

Door Handle Holder

Clean the Griddle Before Use Bottom Heat Shield

Bracket

Wing Bolt

ST514

Fig. 14 Handle holder and heat shield positions.

Reversing the Flue Collar

You can reverse the flue collar by removing the two screws that attach the collar to the back of the stove, as in Figure 15. Be sure the gasket around the flue collar opening is in position when you screw the collar back on to the stove.

 

Flue Collar Screws

 

ST515

Fig. 15

Reversing the flue collar.

 

11

Page 11
Image 11
Vermont Casting 1695CE Assembly, Clean the Griddle Before Use, Set Up the Stove, Install the Bottom Heat Shield, 2000970