Thermostat Lever
INTREPID II
Primary Air Shutter
ST524
Fig. 26 The primary air shutter must move freely.
How to Adjust the Door Latch
Over time, the gasketing around the doors will com- press, and the latch may need adjustment. To adjust the latch, loosen the small locking nut, extend the striker screw one turn while keeping the striker screw from turning. (Fig. 27) Keep making adjustments a little at a time until the setting is right.
The front doors of the stove should close securely and tightly, when the handle is in the closed position. When the latch is properly adjusted there should be a slight resistance as the doors are moved to the completely closed position.
Pawl
Small Lock- ing Nut
Striker Screw
Large Lock-
ing Nut 
Set Screw
Handle Stub
ST531
Fig. 27 Turn the door latch striker screw in or out to tighten or loosen the door latch.
Tighten the Damper Handle as Needed
The damper handle is attached to the damper rod with a set screw bearing against a flat spot on the rod. Check the set screw periodically for tightness; tighten as needed.
Vermont Castings Intrepid
Damper Adjustment
When the stove damper is closed, the pressure of the rod against the damper plate assures a good seal be- tween the damper and the damper housing. Adjustment may be needed after a period of time to retain adequate pressure.
To make this adjustment, start with the damper in the closed and locked position. (Fig. 28) Loosen the 7/16” locking nut in the center of the damper. Use a 1/8” Allen wrench to turn the Allen screw a full turn clockwise. Test the damper for snugness, and continue adjusting the Allen screw as needed. Tighten the 7/16” locking nut when the damper operates smoothly but firmly.
Thermostat Cover |
|
| |
Damper Actuator | Handle |
Rod | |
| Damper |
| Allen Head Ad- |
| justment Screw |
Locking Nut | ST532 |
Fig. 28 Tighten the damper adjustment screw for a snug seal.
Replace the Stove Gaskets as Needed
The Intrepid uses fiberglass rope gaskets to make a tight seal between some parts. With use, particularly on those parts that move, gaskets can become brittle and compressed, and can begin to lose their effectiveness. These will need periodic replacement.
The sizes of replaceable gasket are listed below, along with their applications.
Gasket Diameter ...And the Parts it Seals 5/16” wire gasket The griddle to the stove top
5/16”The damper to the upper fire- back; the front doors to the stove front; and the door halves to each other
3/16”The glass panes to the door
Refer to Page 18 for information on replacing the glass panels or its gasket.
If you need to change a gasket, first obtain an appropri- ate replacement from your Vermont Castings Dealer.
2000970 | 19 |
