NSF requires that the brewer be able to be moved for cleaning underneath. A flex line or loops of copper tubing will satisfy this requirement. See Figure 2 below.
INSTALLATION (continued)
NOTE: This equipment must be installed to comply with applicable federal, state and local plumbing codes and ordinances.
Water Supply Installation
In some areas, local codes require a backflow preventer (check valve) to be installed on the inlet water line. If a backflow preventer is used, you must install a water hammer arrester in the incoming line, between the backflow preventer and the brewer inlet, as far away from the brewer as space will allow. This will relieve the excessive back pressures that can cause faucet leaks and solenoid malfunctions.
IMPORTANT:
Tank must be full of water before connecting brewer to electrical power. Heating elements will be damaged if allowed to operate without being fully submerged in water. Damage caused by operating the brewer without water in the tank is NOT COVERED BY WARRANTY.
ELECTRICIAN’S INSTALLATION INSTRUCTIONS
REFER TO ELECTRICAL SPECIFICATIONS provided in the Owner's Manual, specification sheet, and on the nameplate.
Some models are equipped with a cord and plug. They require:
1.A circuit that meets or exceeds the electrical requirements
2.A properly installed and grounded receptacle configured to match the brewer plug.
Some models are designed to be connected directly to the electrical circuit. They require:
1.A circuit that meets or exceeds the electrical requirements
2.Conduit and fittings that meet applicable electrical codes.
3.The ground lug of the brewer must be connected to a suitable electrical ground.
WARNING:
SHOCK HAZARD
Brewer must be properly grounded to prevent possible shock hazard. DO NOT assume a plumbing line will provide such a ground. Electrical shock will cause death or serious injury.
IMPORTANT:
Supply power must match nameplate for voltage and phase. Connecting to the wrong voltage will damage the brewer or result in decreased performance. Such damage is not covered by warranty.
IMPORTANT:
The ground prong of the plug is part of a system designed to protect you from electrical shock in the event of internal damage. Never cut off the ground prong nor twist a blade to fit an existing receptacle. Contact a licensed electrician to install the proper circuit and receptacle.
GROUND
PIN
NEMA | NEMA |
PLUG | RECEPTACLE |
Typical Plug/Receptacle
Configuration
3
