PREPARATION

 

Place one (1) genuine Bloomfield

PAPER

paper filter in the brew chamber.

FILTER

Add a pre-measured amount of

 

fresh coffee grounds.

 

Gently shake the brew chamber to

BREW

level the bed of grounds. Slide the

CHAMBER

 

brew chamber into place under the

 

brew head.

Brew Chamber

POUR-OVER OPERATION

BE sure “READY TO BREW” light is lit.

Place the appropriate EMPTY decanter in place under the brew chamber.

Fill a decanter with tap water. Lift the pour-over cover and pour the entire contents of the decanter into the pour-over opening, which will fill the basin.

Water from the basin will displace a like amount of heated water from the tank. The hot water will be forced into the brew head where it will spray over the bed of grounds. Freshly brewed coffee will begin to fill the container under the brew chamber. When the flow and all dripping stops, the coffee is ready to serve.

Discard the contents of the brew chamber. Rinse the brew chamber in a sink. When the ”READY TO BREW” light glows, the brewer is ready for another brew cycle.

AUTOMATIC OPERATION

BE sure “READY TO BREW” light is lit.

Place an EMPTY decanter in place under the brew chamber.

Press the “BREW” switch. The solenoid will open for an amount of time determined by the timer setting, admitting a measured quantity of water into the basin.

Water from the basin will displace a like amount of heated water from the tank. The hot water will be forced into the brew head where it will spray over the bed of grounds. Freshly brewed coffee will begin to fill the decanter under the brew chamber. When the coffee flow and all dripping stops, the coffee is ready to serve.

Discard the contents of the brew chamber and rinse it in a sink. When the ”READY TO BREW” light glows, the brewer is ready for another brew cycle.

NOTE: Water for the hot water faucet is heated in a coil inside of the water tank. Use of the faucet will not affect the volume of water delivered for a brew. However, overuse of the faucet during a brew may lower the temperature of the brew water.

BREWING COFFEE

CAUTION:

Burn Hazard

Exposed surfaces of the brewer, brew chamber and decanter may be HOT to the touch, and can cause serious burns.

CAUTION:

Burn Hazard

To avoid splashing or over- flowing hot liquids, ALWAYS place an empty decanter under the brew chamber before starting the brew cycle. Failure to comply can cause serious burns.

CAUTION:

Burn Hazard

After a brew cycle, brew chamber contents are HOT. Remove the brew chamber and dispose of used grounds with care. Failure to comply can cause serious burns.

IMPORTANT: Before operating the brewer for the first time, the tank must be filled with water BEFORE connecting to electric power.

Place an empty decanter under the brew head, then pour decanters of water into the pour-over opening until water flows from the brew head.

5

Page 7
Image 7
Bloomfield 600 manual Brewing Coffee, Preparation, POUR-OVER Operation, Automatic Operation