Built-In Outdoor Grill Installation
Built-In ArchitectTM Series Outdoor Grill
Make gas connections
WARNING
Fire Hazard
Do not use grill near combustible materials. Do not store combustible materials near grill. Doing so can result in death or fire.
IMPORTANT: If grill is to be installed in a combustible enclosure, return this unit and replace it with the model which is manufac- tured for use in a combustible enclosure.
WARNING
Fire Hazard
Do not install this grill on or near combustible materials.
Doing so can result in death or fire.
WARNING
1.Place grill into outdoor enclosure, but leave enough room in back to connect to gas supply.
WARNING
Explosion Hazard
Use a new CSA International approved “outdoor” gas supply line.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure gas pressure does not exceed 11” (28 cm) water column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and authorized service personnel.
Failure to do so can result in death, explosion, or fire.
NOTE: If grill has been converted to L.P. gas, follow instructions in “If Converted to L.P. Gas” at the end of this section.
2.Natural gas connection only.
A combination of pipe fittings must be used to connect the grill to the existing gas line.
•If local codes permit, use an outdoor flexible stainless steel tubing gas connector,
•
Excessive Weight Hazard
Use two or more people to move and install grill. Failure to do so can result in back or other injury.
Natural Gas Use
This installation must conform with local codes and ordinances. In the absence of local codes, installations must conform with either the National Fuel Gas Code ANSI Z223.1
rear of grill
flexible gas connector
1/2” grill |
gas pipe |
3. Open shutoff valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe.
valve open
valve closed
® Teflon is a registered trademark of E.I. Du Pont de Nemours and Company. 11
